A couple weeks ago, I guest posted this tutorial on I Heart Naptime with Chocolate Sundaes
. Have you been to Jamielynn's blog? You should definitely check it out if you haven't. In case you missed the tutorial, here it is!
A few days ago I saw this picture on Anthropologie
, and I couldn't wait to try making this bag. I don't know about you, but I don't have $500 to spend on a tote. Are you ready? Here's what you'll need:
- 1 yard lining/accent fabric - I used a plaid cotton with no right/wrong side
- 2 yards 3/16 inch cording
- 2/3 yard linen
- Fusible batting (optional)
The first thing you will want to do is iron and cut all your fabric. From the lining/accent fabric cut:
- one piece - 6" x 26" (bow)
- two pieces - 6" x 2" (bow tie)
- two pieces - 30" x 1.5" (cording wrap)
- four pieces - 2" x 22" (straps)
- four pieces - 13" x 5" (top edge inside and outside)
- two pieces - 15" x 13" (inside front and back)
- one piece - 15" x 7" (inside bottom)
- two pieces 7" x 13" (inside sides)
From the linen cut:
- two pieces - 15" x 13" (outside front and back)
- one piece - 15" x 7" (outside bottom)
- two pieces 7" x 13" (outside sides)
From the stabilizer cut:
- two pieces 15" x 7" (bottom)
- two pieces 13" x 5" (top)
From the batting cut (you can use stabilizer instead, or extra fabric):
- two pieces 2" x 22" (straps)
Now you're ready to start sewing. The first thing you will want to do is pleat your linen. To make the front and back pleats, take the outside front and fold in half along the 15" side. Set your stitch length to 4 or 5 and sew a line .5" from the fold. You only need to sew it a few inches long.
Measure 2" from the first fold and make another fold. Sew another line at that fold. Repeat until you have five sewn folds. All the folds should be on the same side of the fabric. Repeat for the outside back piece.
For the sides, you will sew only one pleat. Sew a line 1.5" from the fold.
Set your stitch length back to 2.5. Sew the two pieces of stabilizer to the outside bottom (I found it easier to sew the two pieces of stabilizer together first, then sew them to the bottom). Sew .25" from edge.
Using a .5" seam allowance, sew the front and back to the bottom. You want the stabilizer on the outside while you sew as well as the loops you made for pleats (they are on the opposite edge from the seam). Then sew the seam flat to the bottom, sewing .25" from original seam.
Before you sew in the sides, you need to cover your cording. Fold the fabric in half around the cord. Use a zipper foot, or a cord foot to sew the fabric around the cord. You want your seam to be as close as possible to the cord itself. I used a cord foot, which was super easy!
Now sew your sides to the back, front, and bottom of bag with the cording in the seam. Sandwich the cording between the front of the bag and one of the sides. The loops for your pleats should be facing down for the front, and up for the side. Sew together using a .5" seam allowance.
When you get to the seam for the bottom, lower your needle into the fabric, lift your presser foot, and pull the top fabric only to match the new edge. Continue sewing bottom and repeat turn for last corner.
Your corner should look like this:
Repeat for the other side, and trim the tip off the corners, so they aren't as bulky. Fold the seam flat to the bottom and stitch as you did the front and back seams. Your bag should start to look like a bag.
Let's make those pleats look like actual pleats (not loops). Use your fingers to press the loops flat as you sew a .25" seam around the top of the bag. The center of each fold should match up to the seam of each pleat. Then change your stitch length to 4 and repeat about 1" further in from original seam.
You are almost finished with the outside of the bag. The final part for the outside is to add the top accent fabric. Change your stitch length back to 2.5 and sew two of the top pieces together on both short sides with a .5" seam allowance. You should now have a loop of fabric. Repeat for the stabilizer. I sewed the seam open and flat on the stabilizer to make it easier to work with in the bag.
Pin the stabilizer, accent loop, and outside bag together (all of your right sides should be facing in). Line up the side seams with the center of your side pleat. Then, use a .5" seam allowance to sew all layers together.
When you fold the flap up, it should look like this:
You will repeat these same steps for the lining of the bag. The only differences are that the lining does not use any stabilizer or cording, and you will leave about a 5" gap in your seam on one side to pull the bag right-side-out.
Before sewing the lining to the bag, you need to make the straps. Stack the batting (you could use stabilizer or extra fabric instead) on top of two layers of strap fabric (if you use fabric with right sides, put both right sides together). Sew along the long edges .25" from edge. Turn the straps right side out, and sew along the edge as close as possible. Iron when you are done.
Turn the bag right side out, measure 3" from the side seam, and pin the straps to the bag.
Slide the lining over the outside bag with the lining facing right-side-in. Pin the lining to the bag (make sure you get the straps pinned) matching the side seams. Again, use a .5" seam allowance, sew the lining to the bag.
Turn the bag right-side-out by pulling it through the gap you left in the lining. Sew the gap shut either by hand or machine.
To finish the bag, pick out the pleat seams, and the stabilizing seam. Then, you will sew around the top .25" from the top edge, and again .25" from the pleated edge.
I adorned the top with a fabric bow, but you could use a flower or any other embellishment, or even leave it plain.
After all that work, I decided that the bag just didn't fit my needs. I really need a new purse, but this is more of a tote. I am a sucker for totes, but I already have about ten of them. So I guess I will be selling this one on etsy.
I will be showing these off at these link parties
Oh my gosh, what a great tutorial! Thanks for stoppin' by DIY Addict! I'm your newest follower + this comment = you get to do a little dance and squeel for joy, so have fun!ReplyDelete
Wow thats suuuuper impressive how close yours looks to the anthro one! Awesome job!ReplyDelete
~ Jen @ http://pinstripestopearls.blogspot.com
yes. it is decided. you are the craftiest girl i know. your tote is totally better than anthropologie, which i'm sure costs a million dollars. go M!ReplyDelete
Okay, first of all: I saved the picture for the feature (oh hey, I featured you today!) and almost saved the pic of the original on accident because they look THAT similar. Second of all: oh my word, so amazing. I'm going to attempt one of my own. You have a real talent. :)ReplyDelete
I am inspired!!! Thank you for sharing :)ReplyDelete
WOW!! Awesome tutorial - lots of great pics and clear instructions!! Very nice - I like yours better that the original!!ReplyDelete
Whoa. This is so awesomely adorable. I may just get inspired to make one, too. Well done!ReplyDelete
Wow - That bag is too cute and your instructions are great...I might have to give it a try!!ReplyDelete
WONDERFUL tutorial! The bag is adorable!!! Thanks SO much for linking up to Thrilling Thursday @ Paisley Passions. I hope you stop by again soon :)ReplyDelete
~Lori @ Paisley Passions
Beautiful! Thanks for sharing!ReplyDelete
Oh I totally love this! Great tutorial. I'd love for you to submit this to the M&T Spotlight at http://www.makeandtakes.com/spotlightReplyDelete
waw really very interestingReplyDelete
Thanks for this beautiful bagReplyDelete
Thanks for sharing. This is an awesom toteReplyDelete
This is just gorgeous. I love fiddling with cute things to make. Will definately try this one!!ReplyDelete
Hi! Great tutorial and am considering making it. How large is it when finished and how large is the opening?ReplyDelete
This bag is amazing and definitely helps my mild addiction to Anthropologie. I love the bow and the pleats! The tutorial is wonderful.ReplyDelete